西门子授权PLC模块代理商/中国触摸屏总代理商
西门子授权PLC模块代理商/中国触摸屏总代理商
TRAMAT/OXYMAT 6 气体分析仪两个分析仪将 ULTRAMAT 6 和 OXYMAT 6 分析仪组装在一个同一机壳中。
ULTRAMAT 6 测量通道按 NDIR 双光束差分模式工作，并高选择性测量吸收带位于 2 至 9 µm 红外波长范围内的气体，如一氧化碳、二氧化碳、二氧化硫、氨气、水、甲烷以及其它烃。
OXYMAT 6 测量通道采用交变顺磁压力方法来检测气体中氧浓度。
大型液晶显示屏，用于同时显示以下各项：
测量值（数字和模拟量显示）
状态栏
量程
可通过菜单操作调节液晶显示器的对比度
LED背照明
配有五个软键的可清洗薄膜型键盘
可通过菜单操作实现参数化、测试功能、调整
纯文本用户帮助
可图形显示走势图；时间间隔可设定
双语操作软件：
德语/英语，英语/西班牙语，法语/英语，西班牙语/英语，意大利语/英语。
每个所测组分的一个模拟量输出点
两个可以自由配置的模拟输入（例如用于交叉校正或外部压力传感器）
6 个可自由组态的数字量输入（例如用于量程切换、处理来自样气制备的外部信号）
6 个可自由配置的继电器输出，例如用于故障处理或维护要求、极限报警、外部电磁阀
可通过的 8 路数字量输入和 8 路继电器输出进行扩展，例如可使用多 4 种校准气进行自动校准
Corrosion-resistant materials in gas path (option)
Measurement possible in highly corrosive sample gases
Sample chambers can be cleaned as required on site
Cost savings due to reuse after contamination
Open interface architecture (RS 485, RS 232, PROFIBUS)
SIPROM GA network for maintenance and servicing information (option)
ULTRAMAT channelHigh selectivity with double-layer detector and optical coupler
Reliable measurements even in complex gas mixtures
Low detection limits
Measurements with low concentrations
OXYMAT channelParamagnetic alternating pressure principle
Small measuring ranges (0 to 0.5% or 99.5 to O2)
Absolute linearity
Detector element has no contact with the sample gas
Can be used to measure corrosive gases
Long service life
Physically suppressed zero through suitable selection of reference gas (air or O2), e.g. 98 to O2 for purity monitoring/air separation
西门子授权PLC模块代理商/中国触摸屏总代理商
Measurement for boiler control in combustion plants
Emission measurements in combustion plants
Measurement in the automotive industry (test benches)
Process gas concentrations in chemical plants
Trace measurements in pure gas processes
Environmental protection
TLV (Threshold Limit Value) monitoring at the workplace
Quality mon
Special applications
Besides the standard combinations, special applications concerning material in the gas path, material in the sample chambers (e.g. titanium, Hastelloy C22) and measured components are available on request.
Performance-tested version / QAL
For measurements of CO, NO, SO2 and O2 according to sections 13 and 27 of the German Federal Immission Protection Regulations and TA Luft, performance-tested versions according to EN 15267 of the ULTRAMAT/OXYMAT 6 are available.
Certified measuring range:
1-component analyzer西门子授权PLC模块代理商/中国触摸屏总代理商
CO: 0 to 75 mg/m³; 0 to 10 000 mg/m³
NO: 0 to 100 mg/m3; 0 to 10 000 mg/m³
SO2: 0 to 75 mg/m3; 0 to 1 500 mg/m³
O2: 0 to 5 vol.%; 0 to 25 vol.%
All larger measuring ranges are also approved.
In addition, performance-tested versions of the ULTRAMAT/OXYMAT 6 meet the requirements set forth in EN 14956 and QAL1 according to EN 14181. Conformity of the analyzers with both standards is TÜV-certified.
Determination of the analyzer drift according to EN 14181 (QAL3) can be carried out manually or also with a PC using the SIPROM GA maintenance and servicing software. In addition, selected manufacturers of emission evaluation computers offer the possibility for downloading the drift data via the analyzer's serial interface and to automatically record and process it in the evaluation computer.
Flow-type reference cell西门子授权PLC模块代理商/中国触摸屏总代理商
The flow through the reference cell should be adapted to the sample gas flow
The gas supply of the reduced flow-type reference cell should have a primary pressure of 3 000 to 5 000 hPa (abs.). Then a restrictor will automatically adjust the flow to approximately 8 hPa
19" rack unit with 4 U for installation
In hinged frame
In cabinets with or without telescopic rails
Front plate can be swung down for servicing purposes (laptop connection)
Internal gas paths: hose made of FKM (Viton) or pipe made of titanium or stainless steel
Gas connections for sample gas inlet and outlet: pipe diameter 6 mm or 1/4"
Flow indicator for sample gas on front plate (option)
Sample chamber (OXYMAT channel) – with or without flow-type compensation branch – made of stainless steel (mat. no. 1.4571) or of tantalum for highly corrosive sample gases (e.g. HCl, Cl2, SO2, SO3, etc.)
Monitoring (option) of sample gas and/or reference gas (both channels)
Display and operator panelLarge LCD panel for simultaneous display of:
Measured value (digital and analog displays)
Status bar
Measuring ranges西门子授权PLC模块代理商/中国触摸屏总代理商
Contrast of LCD panel adjustable using menu
Permanent LED backlighting
Washable membrane keyboard with five softkeys
Menu-driven operation for parameterization, test functions, adjustment
User help in plain text
Graphic display of concentration trend; programmable time intervals
Bilingual operating software:
German/English, English/Spanish, French/English, Italian/English, Spanish/English
One analog output for each measured component
Two analog inputs freely configurable (e.g. correction of cross-interference or external pressure sensor)
Six digital inputs freely configurable (e.g. for measuring range switchover, processing of external signals from sample preparation)
Six relay outputs freely configurable e.g. for fault, maintenance demanded, limit alarm, external solenoid valves
Expandable with eight additional digital inputs and eight additional relay outputs e.g. for autocalibration with up to four calibration gases
CommunicationRS 485 present in the basic unit (connection at the rear; for the rack unit also behind the front plate).
Options西门子授权PLC模块代理商/中国触摸屏总代理商
AK interface for the automotive industry with extended functions
RS 485/RS 232 converter
RS 485/Ethernet converter
RS 485/USB converter
Connection to networks via PROFIBUS DP/PA interface
SIPROM GA software as the service and maintenance tool
ULTRAMAT/OXYMAT 6, membrane keyboard and graphic display
Designs – Parts wetted by sample gas, standard概述ULTRAMAT/OXYMAT 6 气体分析仪两个分析仪将 ULTRAMAT 6 和 OXYMAT 6 分析仪组装在一个同一机壳中。
西门子授权PLC模块代理商/中国触摸屏总代理商
气路采用耐腐蚀性材料（可选）
可用于测量强腐蚀性样气
可根据需要现场清洁样本室。
由于污染后可以重新使用，因此可节约成本
开放式接口体系结构（RS 485、RS 232、PROFIBUS）
用于维护和服务信息的 SIPROM GA 网络（可选）
ULTRAMAT 通道双层检测器和光耦合器，选择性好
对复杂的气体混合物也能可靠测量
检测极限值低
可测低浓度
OXYMAT 通道顺磁压力变化原理
小量程测量（0 ～ 0.5% 或 99.5 ～ ）O2）
完全线性
检测单元与样气无接触
可用于测量腐蚀性气体
使用寿命长
通过选取合适的参比气体（空气或 O2），例如纯气体检测或空分中 O2 浓度 98 ～ ，可以实现零点自校正。
在焚烧厂中用作锅炉控制测量
焚化装置排放监测
汽车工业测量（试验台）
化工厂中的工艺气体浓度测量
高纯气体的品质检验
环境保护
工作场所 TLV（阈限值）监视
质量监控
特殊型号特殊应用
除标准组合外，还可按需提供涉及气路材质、采样小室材质（如钛、哈氏合金 C22）和采样组件等的特殊应用。
经性能测试的型号 / QAL
用于根据第 13 和第 27 烟气法规(BlmSchV) 和大气质量控制技术规范 (TA Luft) 测量一氧化碳、一氧化氮、二氧化硫和氧气，提供了根据 EN 15267 进行了性能测试的 ULTRAMAT/OXYMAT 6 型号。
经过认证的测量范围：
单组分分析仪
CO：0 至 75 mg/m³；0 至 10 000 mg/m³
一氧化氮：0 至 100 mg/m3；0 至 10 000 mg/m³
SO2：0 至 75 mg/m3；0 至 1 500 mg/m³
O2:0 至 5 vol.%; 0 至 25 vol.%
三组分分析仪。
另外，经过性能测试的 ULTRAMAT/OXYMAT 6 型号还符合 EN 14956 以及 EN 14181 的 QAL 1 中提出的要求。分析仪符合这两个标准已经过 TÜV 认证。
分析仪的漂移可以根据 EN 14181（QAL 3）标准手工测定，或使用 SIPROM GA 维护和维修软件通过 PC 测定。而且，选定制造商提供的辐射评估电脑可以通过分析仪的串口下载漂移数据，并在评估电脑上进行自动记录和处理。
流量型参比室
通过参考隔室的流量应适应样气流量
减流型隔室的气体供应上游压力应为 3 000 至 5 000 hPa（）。然后，限流器将流量压力自动调节为约 8 hPa
19" 机架式，具有 4 HU 高度
处于铰链机架中
处于有或无伸缩导轨的机柜中
前面板维护时可以放下来（连接便携式电脑）
内部气体路径：使用由 FKM (Viton)材料制成软管，或钛管或不锈钢管
用于样气气路入口和出口的气路连接件：管径 6 mm 或 1/4"
前面板上有样气流量指示器
样气室（OXYMAT 通道）- 带或不带流动型补偿支路 - 材质为不锈钢（牌号：1.4571）或钽以防高腐蚀样气（如HCl，Cl2, SO2, SO3，等）的腐蚀
监控（可选）样气和/或参比气（均包括）
显示和控制面板。
西门子授权PLC模块代理商/中国触摸屏总代理商
